Difference between revisions of "Airswept Turbo Dryers"
(Created page with "Category:Drying{{Knoppen}} <noinclude><!------------------------------------------------ * READ THIS FIRST * Only edit this page if you can improve the content. * Improper u...") |
|||
| Line 7: | Line 7: | ||
* Please start editing this page after the /noinclude | * Please start editing this page after the /noinclude | ||
* -------------------------------------------------></noinclude> | * -------------------------------------------------></noinclude> | ||
[[File:Ast_dryer2.jpg|thumb|200px|right|AirSwept Tubular Dryer]] | |||
The '''AirSwept Tubular Dryers''' are a new concept in drying technology. Manufactured in the United States, it will process anything from low solids slurries to low moisture powders. The flow of material through the dryer is controlled so that the product may be a fine, dry powder or a moist granular material. | |||
Three separate zones in the dryer control the rate of drying with the central retention zone determining the residual moisture content and physical size of the product. | |||
High temperature differentials are used but as with most flash dryers, the product temperature is lower than the wet-bulb temperature of the system. | |||
The heat source for the dryer is an oil or gas fired hot air generator, usually integrated with the drying cylinder. | |||
Product collection can be directly from the final zone of the drying tube, from a cyclone or from a bag filter. The dryer is manufactured in nine sizes with evaporation rates as high as eight tonnes per hour. | |||
Revision as of 09:45, 25 July 2012
The AirSwept Tubular Dryers are a new concept in drying technology. Manufactured in the United States, it will process anything from low solids slurries to low moisture powders. The flow of material through the dryer is controlled so that the product may be a fine, dry powder or a moist granular material. Three separate zones in the dryer control the rate of drying with the central retention zone determining the residual moisture content and physical size of the product. High temperature differentials are used but as with most flash dryers, the product temperature is lower than the wet-bulb temperature of the system. The heat source for the dryer is an oil or gas fired hot air generator, usually integrated with the drying cylinder. Product collection can be directly from the final zone of the drying tube, from a cyclone or from a bag filter. The dryer is manufactured in nine sizes with evaporation rates as high as eight tonnes per hour.