Difference between revisions of "Compression Crushers"
Jump to navigation
Jump to search
(Created page with "Category:Particle Size Reduction{{Knoppen}} <noinclude><!------------------------------------------------ * READ THIS FIRST * Only edit this page if you can improve the ...") |
|||
| (5 intermediate revisions by the same user not shown) | |||
| Line 7: | Line 7: | ||
* Please start editing this page after the /noinclude | * Please start editing this page after the /noinclude | ||
* -------------------------------------------------></noinclude> | * -------------------------------------------------></noinclude> | ||
[[File:Compression_Crushers.png.jpg|thumb|right|Compression Crusher Principle]] | |||
'''Compression crushing''' is a type material reduction ([[Crushers |crushing]]) method that uses a compression force between two surfaces. The pressure between the plates makes the material shatter in too smaller particles. | |||
==Used== | |||
*If the material is hard and tough | |||
*If the material is abrasive | |||
*If the material is not sticky | |||
*When the material will break cubically | |||
==Crusher types== | |||
*[[Gyradisc Crushers]] | |||
*[[Jaw Crushers]] | |||
*[[Roll Crushers]] | |||
*[[Hammer Crushers]] | |||
==Other crushing methods== | |||
*[[Impact Crushers]] | |||
*[[Shear Crushers]] | |||
*[[Attrition Crushers]] | |||
Latest revision as of 04:50, 3 February 2012
Compression crushing is a type material reduction (crushing) method that uses a compression force between two surfaces. The pressure between the plates makes the material shatter in too smaller particles.
Used
- If the material is hard and tough
- If the material is abrasive
- If the material is not sticky
- When the material will break cubically
Crusher types